So, after cleaning the brass in the wet tumbler followed by a short stint in the dry media, I wound up with some nice, shiny brass, as shown in some of the previous pix. Next stage was to size the brass, followed by length check. To my surprise, I had a half dozen cases that exceeded SAAMI max length measurements, so I set up the trimmer for "trim-to length" and began creating tiny brass shavings all over the loading bench. I figure if you're gonna do a half dozen, best to make them all uniform. That's what I did.
Kinda surprising that brass would stretch after one firing. Once they were all trimmed and chamfered & deburred, they are looking pretty good! Back into the dry tumbler to get any remaining case lube removed they go...
