Colt Country | Home of The Almighty Colt
Black Powder Pistols => Army Models => Topic started by: DragoonRick on January 27, 2024, 04:15:24 PM
-
I’ve reported on this new to me Pietta 1860 sheriff. It’s a beautiful revolver. I noticed damage to the cylinder notches done by the bolt. There must be a lacker finish that was chipped or scratched. If the cylinder and bolt are out of line this can only get worse.
If any of you have an observation I’d like to hear it.
-
Hand is too short and it looks like the bolt leg is also too short.
-
I took it apart and found the hand spring was to tight. It pushed the cylinder forward. Now the cylinder turns and fits the bolt . The revolver shoots well. I really like this shooter.
-
I took it apart and found the hand spring was to tight. It pushed the cylinder forward. Now the cylinder turns and fits the bolt . The revolver shoots well. I really like this shooter.
The hand is supposed to push the cylinder forward. The tension it imparts supplies the braking force needed to keep throw-by from happening. You should have .003" - .004" endshake to maintain ignition reliability. It looks like the bolt is riding too far to the rear of the notch ( that allows throw-by as well), it should track in the middle ( slightly forward of middle is ok).
Mike
-
The hand is supposed to push the cylinder forward. The tension it imparts supplies the braking force needed to keep throw-by from happening. You should have .003" - .004" endshake to maintain ignition reliability. It looks like the bolt is riding too far to the rear of the notch ( that allows throw-by as well), it should track in the middle ( slightly forward of middle is ok).
Mike
[/quote]
If the bolt is riding to far to the rear of the notch what would be the fix for this?
-
[/quote]
If the bolt is riding to far to the rear of the notch what would be the fix for this?
[/quote]
Remove material from the rear of the head of the bolt.
Mike
-
If the bolt is riding to far to the rear of the notch what would be the fix for this?
[/quote]
Remove material from the rear of the head of the bolt.
Mike
[/quote]
Mike, howdy. sort of like gently sanding the rear of the bolt (Rounding it off where it contacts the cylinder) so to speak? Makes good sense.
-
[quote ]
Mike, howdy. sort of like gently sanding the rear of the bolt (Rounding it off where it contacts the cylinder) so to speak? Makes good sense.
[/quote]
Yes . . . well it will take a while if done gently!! (7+"
A Dremel flex shaft mounted in a vice with a 1/2" sanding drum will allow quicker sanding and you can control it very easily.
-
[quote ]
Mike, howdy. sort of like gently sanding the rear of the bolt (Rounding it off where it contacts the cylinder) so to speak? Makes good sense.
Yes . . . well it will take a while if done gently!! (7+"
A Dremel flex shaft mounted in a vice with a 1/2" sanding drum will allow quicker sanding and you can control it very easily.
[/quote]
Mike😂 thanks man. (7+" Let me show further ignorance. I assume you take the bolt out and place in a vise?
-
If the bolt is riding to far to the rear of the notch what would be the fix for this?
[/quote]
Remove material from the rear of the head of the bolt.
Mike
[/quote]
Thanks Dragoon
I had it in mind that there was a misalignment between the cylinder notches and the bolt hole in the frame.
-
Mike? Remove the bolt ???and place in a vise when using the dremel?