Colt Country | Home of The Almighty Colt
Black Powder Pistols => Colt's Southern Cousins => Schneider & Glassick => Topic started by: Rcampb6131 on May 26, 2016, 12:41:21 PM
-
Top to bottom: a Luciano Giacosa (GLB) imported by EIG Cutley of Miami, FL, dated 1966; a Pietta by swapping the barrel assemblies between a Griawold & Gunnison and an 1851 Navy; a Riva Esterina imported by FIE and dated 1975; and a Fusav di Bini & Baronio dated 1978.
-
Top to bottom: a Luciano Giacosa (GLB) imported by EIG Cutley of Miami, FL, dated 1966; a Pietta by swapping the barrel assemblies between a Griawold & Gunnison and an 1851 Navy; a Riva Esterina imported by FIE and dated 1975; and a Fusav di Bini & Baronio dated 1978.
Way Cool !!
-
Nice set of brassers, and from a couple of the lesser known makers of yesteryear.
-
Top to bottom: a Luciano Giacosa (GLB) imported by EIG Cutley of Miami, FL, dated 1966; a Pietta by swapping the barrel assemblies between a Griswold & Gunnison and an 1851 Navy; a Riva Esterina imported by FIE and dated 1975; and a Fusav di Bini & Baronio dated 1978.
I like the wood on #2 and #4. The wood on number #1 reminds me of the stuff High Standard put on their guns when they were producing replicas. Too blond, too ugly.
Bolded: I have done that and am awaiting funds to purchase a Pietta 1851 Navy steel .36 round TG in order to create the following pistols (all Pietta .36) in addition to the 2 Pietta pistols I have:
1851 Navy Second Model Squareback Trigger Guard
1851 Navy Third Model Round Trigger Guard
G&G .36
S&G .36
Leech and Rigdon .36
And my favorite fantasy pistol: an 1851 Navy Second Model Dragoon .36 Squareback TG with the part round/part octagon barrel. I love the 1851 Navy for its lines but this is a sweeter design. A 2nd Model Dragoon in a smaller package.
I am also awaiting word insofar as the Pietta Dance & Brothers .44 as to whether it has a frame like the Pietta 1851 Navy. I have a hard time believing that Pietta would set up a new machining operation to slightly manipulate the frame, screw locations, et al.
I would like to have a Pietta Dance .36, and I have documents that ascertain that Dance actually produced a few revolvers that had recoil shields.
We shall see...
Jim
-
Sweet collection!
Not to be nit-picky, but only the top two could pass as S&G's as the bottom two have roll engraved cylinders.
But who cares, right? Way cool guns and rarities to boot. Enjoy!
-
You are correct, the cylinder engraving detracts from the authenticity, but I have hesitated to remove it for fear of screwing up the cylinders. Since they are fairly rare maybe I should just leave them alone.
RC
-
Nice set of brass framed revolvers. Ya, go ahead and leave the roll engraving on the two since they are rare.
^^^^+1
Nothing like an original repro that can't be duplicated.
Heck, you have a Pietta swap with a plain cylinder to show off. Leave the original early Italians alone. They will be worth money in the long run.
I am envious. Nice collection, sir.
Jim